Cabinet Hardware Placement Standards

Hardware on wall cabinets.

Cabinet hardware placement standards. For example knobs will go between 6 2 and 10 cm 2 5 and 4 inches from the bottom edge of the door centred in the stile. Cabinet door hardware placement guidelines taylorcraft cabinet door company for knobs we recommend the knob holes be centered horizontally on the door stile and on upper cabinets place knob holes 2 1 2 up from the bottom of the door. For pulls you will want the end of the pull to be in this position. For slab doors you will want the hole placement to be equidistant from the bottom and side of the cabinet.

When it comes to installing cabinet door handles either knobs or pulls they are always placed on the opposite side from the door hinges. The guideline for hanging cabinet pulls is the same as hanging knobs i e. On lower cabinets place knob holes 2 1 2 down from the top of the door. To find the correct spot for hardware on your upper cabinets follow the base cabinetry guidelines but measure up from the bottom of the door.

Hardware placement on cabinet doors once you have decided on if you will use pulls or knobs or a mix of both it s time to decide where exactly to install them on doors and drawers. However some kitchens may use all knobs or all pulls or any combination that best suits your style. 2 is typically a good distance. Pulls begin 3 7 cm 1 5 inches up from the bottom.

Let s look at a few options. For 5 piece cabinets like a shaker or any style that isn t one flat slab of wood the traditional placement is to center the knob in the corner of the face frame so that the knob is in the center of both the vertical and horizontal frame pieces. Unlike drawer cabinetry hardware placement for door cabinetry is much more subjective. Adjust the screw hole placement accordingly if necessary.

The hardware spacing for the wall cabinets should match the base cabinets. Traditionally knobs are used on cabinet doors and pulls handles are used on drawers. When mounting knobs on cabinet doors place the knob in the corner of the door. However there is one slight difference.

A general rule of thumb with cabinet hardware placement and pairing. On upper cabinets the bottom screw hole should be placed 2 5 3 above the bottom of the door. Framed drawer front under 24. The knob or pull can align with the rail or it could be higher or lower there are no rules.

Well except for this rule. This is obviously not always the case but it s an easy way play it safe and still guarantee a professional look. Cabinet pulls have two screws as opposed to only one screw with a knob. Because most drawer fronts are under 24 wide simply installing the knob centered both vertically and horizontally is common.